Table of Contents
Advertisement
Tremolo Mode
When Tremolo mode is selected, the Fade In and Onset controls are set to
zero and the Trem/Fade module behaves as a 'normal' tremolo effect. How-
ever, the Fade In and Onset controls are still active and can be adjusted as
desired.
Two Tremolo modes are available. Each has different settings but the controls
behave exactly the same in both modes.
Note:
Tremolo mode, you will not hear the tremolo effect.
VariTrem Mode
In VariTrem mode, the tremolo rate is automatically increased or decreased in
realtime. The rate is ramped up or down according to the value of the Onset
control. For example, if VariTrem Up is selected and Onset has a value of 2
seconds, the Tremolo rate will gradually increase for 2 seconds.
Two VariTrem modes are available. Vari T Up gradually increases the Trem-
olo rate, and Vari T Dn gradually decreases the Tremolo rate.
Note:
VariTrem mode, you will not hear the VariTrem effect.
Enables or disables Trem/Fade. You can use this switch to compare the
Trem/Fade
On/Off Button
Trem/Fade settings to that of the original signal or to disable Trem/Fade am-
plitude processing.
UAD DSP load is not reduced when Trem/Fade is disabled with the On/Off
button. The Trem/Fade amplitude processor remains active even when its au-
dio is disabled so it can be used as a modulation source when using "Trem"
as the LFO Type in the Mod Delay module.
UAD Powered Plug-Ins Manual
If the Depth value is zero and/or the Threshold value is set too high in
If the Depth value is zero and/or the Threshold value is set too high in
- 414 -
Chapter 38: Nigel
Advertisement
Table of Contents
