Table of Contents
Advertisement
Attack
Attack sets the amount of time that must elapse once the input signal reaches
the Threshold level before processing is applied. The faster the Attack, the
more rapidly processing is applied to signals above the threshold.
The available range is 50 microseconds to 100 milliseconds.
Release sets the amount of time it takes for processing to cease once the input
Release
signal drops below the threshold level. Slower release times can smooth the
transition that occurs when the signal dips below the threshold, especially use-
ful for material with frequent peaks. However, if you set too large of a Release
time, processing for sections of audio with loud signals may extend to lengthy
sections of audio with lower signals. The available range is 20 milliseconds
to 2 seconds.
The Gain control adjusts the output level of the band. Generally speaking, ad-
Gain
just the Gain control after the desired amount of processing is achieved with
the Threshold control. The Gain control does not affect the amount of process-
ing. The available range is ±12 dB.
Note:
EQ Display (see
For details about the band frequencies, see
Band
Frequencies
page
Band Enable &
For details about the band enable and solo controls, see
Solo
on page
UAD Powered Plug-Ins Manual
The Gain for each band can also be modified by control points in the
"Curve Control Points" on page
470.
471.
"Frequency Controls" on
- 467 -
468).
"Dynamics Meters"
Chapter 46: Precision Multiband
Advertisement
Table of Contents
