Table of Contents
Advertisement
Link
When set to link (down position), modifying any channel one or channel two
control causes its adjacent stereo counterpart control to snap to the same po-
sition (channel 1 & 2 controls are ganged together in link mode).
When link is active, automation data is written and read for channel one
only. In this case, the automation data for channel one will control both chan-
nels.
Note:
surface or when in "controls only" (non-GUI) mode will have no effect.
The Neve 33609 can operate in true stereo or dual-mono mode. This switch
Mono/Stereo
determines the active mode.
Mono
In mono mode, channels 1 and 2 are completely independent and the 33609
functions as a dual-mono device, each channel with its own compressor and
limiter.
Note:
when in mono mode, link mode must be disabled.
Stereo
In stereo mode, the left channel is fed to the channel one compressor, and the
right channel is fed to the channel two compressor. The two compressors are
constrained so that they both compress the same amount at any instant. This
prevents transients which appear only on one channel from shifting the image
of the output. Any big transient on either channel will cause both channels to
compress. The amount of compression will be similar to the amount of com-
pression for a transient which appears on both channels at the same time.
In stereo operation the controls for channels 1 and 2 are independent and
can be set separately. Generally, the channel with the "most processing oc-
curring" controls the processing for the other channel. For example, if the
same signal is fed to both channels in stereo mode and channel 1 has a lower
threshold setting than channel 2, the channel 1 threshold value is used for
both channels. Similarly, if channel 1 were disabled (using "In" switches),
channel 2 settings would be used because "more processing" occurs with the
channel 2 settings. It's not always so simple though, as in the following cases:
UAD Powered Plug-Ins Manual
When link is active, changing channel two parameters from a control
To read and write automation data for both channels independently
- 372 -
Chapter 36: Neve 33609 Compressor
Advertisement
Table of Contents
