Table of Contents
Advertisement
3.
4.
• a) Select the "Install the software automatically (Recommended)" option,
• b) The UAD device driver will be installed, click "Finish" when it is complete.
• c) (UAD-1 only) The New Hardware Wizard will run again to look for the
Software installation is now complete. Proceed to the Authorization section (
You can use the UAD Meter & Control Panel to verify installation (see
ing Installation" on page
Note:
installer again.
Mac Install
Software Installation Procedure for Mac Systems
Important:
fore installing the software and/or launching the UAD Meter & Control Panel
application for the first time.
1.
• To install from CD-ROM, insert the UAD Powered Plug-Ins CD. Open the CD
• To install from a download, first decompress the downloaded .zip archive
2.
3.
Software installation is now complete. Proceed to hardware installation or if that is done
already, proceed to the Authorization section (
UAD Powered Plug-Ins Manual
When installation has completed, power down your system to install the
UAD card(s) following the instructions on
ready installed or you are updating, restart the system.
After restarting, the New Hardware Wizard will try to locate the new driv-
ers. Follow these steps:
and click "Next."
second UAD-1 driver. Select the "Install the software automatically (Recom-
mended)" option, and click "Next." The second UAD-1 driver will be in-
stalled; click "Finish" when it's complete.
If you want to install the UAD plug-ins into another application, run the
Verify the computer system date and time are set correctly be-
Launch the software installer.
window, then double-click the application named "UAD Powered Plug-Ins
Installer."
by double-clicking it. Then double-click the UAD Powered Plug-Ins Installer
application.
The installer will guide you through the installation procedure.
Restart the computer after the software is installed.
page
35.)
page 32
- 29 -
30. If the UAD device is al-
page 32
).
Chapter 2: UAD Installation
).
"Verify-
Advertisement
Table of Contents
