Image Position Correction Sequence In Standby; Outline; Timing Of Operation - Canon CLC5000 Service Manual

CHAPTER 2 NEW FUNCTIONS

3.4 Image Position Correction Sequence in Standby

3.4.1 Outline

The machine executes image position correction while in standby state, and this function
is independent of presses on the Start key.
In the case of a CLC1000 Series machine, image position correction is ex-
ecuted in response to a press on the Start key by the user, forcing the user to
REF.
wait for nearly 1 min once the correction starts.

3.4.2 Timing of Operation

The image position correction sequence is executed as follows:
1. When the power switch is turned on (during initial rotation)
2. A specific period of time after the power switch is turned on (during standby): 12, 20,
35, 60, and 120 min; thereafter, at intervals of 120 min
3. When the transfer unit is slid out and then in (during initial rotation)
The image position correction sequence is automatically expected independently of the
operation of the Start key; however, it is not executed under the following conditions:
1. When an E code is indicated
2. When a jam exists
3. When service mode is used
4. When the hopper is released
5. When the rear cover is removed
6. When it is disabled in service mode (i.e., '0' is set to OPTION>P-OPT>AUTO-REG in
service mode)
2-18
COPYRIGHT © 2001 CANON INC. 2000 2000 2000 2000 CANON CLC5000 REV.0 JAN. 2001