Canon CLC5000 Service Manual page 712

MANAGE
Use it to bring the hues closer to those of professional printing.
If 'MANAGE' is set to '1', the Pro Print key will be indicated on the user
mode screen.
Settings 0: Standard
1: Professional printing (standard: 1)
For fine-adjustment, see the descriptions for 'AJDUST>COL-ADJ>P-
TBL-M/C/Y/K'
OHP-MODE
Select the maximum density when making a copy outo a transparencies.
Settings 0~2 (Standard: 0)
If the value is increased, the density becomes darker.
SMP-NUM
Use it to change the range of sampling of the data representing the color
selected on an original for color conversion.
Settings 0: sample selected color in area of 2x2 (standard)
1: sample selected color in area of 4x4
Remarks In the case of an original composed of dots, correct color identification may
not be identified; if such is the case, set it to '1' to increase the number of
samplings.
*1
THIN-APS
Use it to enable auto paper selection for thin paper.
Settings 0: disable auto paper selection (standard)
1: enable auto paper selection
Remarks Thin paper will not be selected if of the following modes is selected:
• sort, group, staple
• double-sided
*1
SCAN-DWN
Use it to reduce the acceleration speed of the scanner.
Settings 0: standard speed. (default)
1: acceleration speed reduced from standard.
Note 1: You must enter the appropriate value whenever you have replaced reader
controller PCB or initialized a RAM; record any new values on the service
label for this purpose.
Overhead projectors may be either a reflecting type or a transmitting type. It is
best to lower the copy image maximum density for a transmitting type projec-
REF.
tor. Change the value according to the type of projector used by the user.
COPYRIGHT © 2001 CANON INC.
If the image along the leading edge of copies is blurred, the ac-
celeration speed of the scanner may be reduced to eliminate the
REF.
problem.
2000 2000 2000 2000 CANON CLC5000 REV.0 JAN. 2001
SERVICE MODE
S-123