Canon CLC5000 Service Manual page 118

e. Removing the Transfer Belt Motor
1) Slide out the transfer unit assembly to
the front, and open the transfer belt as-
sembly. (See the instructions on how to
open the transfer belt.)
2) Disconnect the connector [1], and re-
move the three screws [2] and the ad-
justing screw [3]; then, detach the trans-
fer belt motor [4].
f. Mounting the Transfer Belt Motor
1) Mount the motor by reversing the steps
used to remove it.
2) Check to make sure that the gap of the
adjusting screw [3] is 4.0 ±0.3 mm.
COPYRIGHT © 2001 CANON INC. 2000 2000 2000 2000 CANON CLC5000 REV.0 JAN. 2001
CHAPTER 2 NEW FUNCTIONS
[1]
[2]
F02-405-71
F02-405-72
[3]
[2]
[4]
[3]
2-79