Canon CLC5000 Service Manual page 701

SERVICE MODE
No.
14 M12 (Transfer belt cleaning motor)
15 M2 (mirror slant correction motor for Y)
16 M3 (mirror ratio correction motor for Y)
17 M5 (mirror slant correction motor for C)
18 M6 (mirror ratio correction motor for C)
19 M7 (mirror slant correction motor for Bk)
20 M8 (mirror ratio correction motor for Bk)
21 M13 (transfer belt swing motor)
22 M23 (duplexing paper jogging guide motor)
23 M28 (duplex reversal motor)
24 M16 (cassette1 lifter motor)
25 M17 (cassette2 lifter motor)
26 M1 (multifeeder lifter motor)
27 M8001 (paper deck motor)
28 Registration shutter motor
29 Y/C/Bk image correction mirror
Ratio correction motor (M3, M6, M8)
30 Y/C/Bk image correction mirror
Slant correction motor (M2, M5, M7)
S-112
Motor
COPYRIGHT © 2001 CANON INC.
Control
Operates for 1 sec and then stops.
Rotates CW for a single full turn, rotates
CCW for a single turn, and then stops.
Rotates CW for a single full turn, rotates
CCW for a single turn, and then stops.
Rotates CW for a single full turn, rotates
CCW for a single turn, and then stops.
Rotates CW for a single full turn, rotates
CCW for a single turn, and then stops.
Rotates CW for a single full turn, rotates
CCW for a single turn, and then stops.
Rotates CW for a single full turn, rotates
CCW for a single turn, and then stops.
Rotates CW for a single full turn, rotates
CCW for a single turn, and then stops.
Executes home position detection, stops for 3
sec, moves to A4 position, stops for 3 sec,
moves to B4 position, stops for 3 sec, moves
to A4R position, stops for 3 sec, moves to
B5R position, stops for 3 sec, and then moves
to home position.
Rotates for draw-in operation for 3 sec, ro-
tates for feed-out operation for 3 sec, stops for
1 sec, rotates for draw-in for 3 sec, rotates for
feed-out for 3 sec, and then stops.
Rotates for lifter-up operation for 3 sec, and
then stops. (Return the lifter by hand.)
Rotates for lifter-up operation for 3 sec, and
then stops. (Return the lifter by hand.)
Rotates for lifter-up operation for 3 sec, stops
for 3 sec, rotates for lifter-down operation for
3 sec, and then stops.
Rotates for lifter-down operation for 10 sec,
rotates for lifter-up operation for 10 sec, and
then stops.
Executes a single registration shutter open/
close operation.
Operates the image correction mirror, and gen-
erates a test pattern (PG=06, grid); then, re-
turns the mirror to original position.
(Each motor may be assumed to be operating
normally if a discrepancy exists between the M
grid and the grid of each color.)
Pick-up will be from the cassette 1; be sure to
put A4/LTR paper in the cassette in advance.
2000 2000 2000 2000 CANON CLC5000 REV.0 JAN. 2001