Canon CLC5000 Service Manual page 320

Step
25 Start service mode, and press
INSTALL
26 Press
DISP COUNTER
ADJUST
FUNC
OPTION
TEST
LSNS-KIL
27 Press
28 Wait until warm-up ends.
During the wait period, perform the
following:
• Set the cassette size to suit the needs of
the user.
• First, set the side guide plate to suit the
paper size. Then, put copy paper in the
cassette, and adjust the trailing edge
guide plate against the trailing edge of
the copy paper.
• Remove the cassette size plate from
each cassette, and attach the appropri-
ate size label; then, put the cassettes
back into their original positions.
• Install the original tray.
If you are installing a paper
deck, you must remove the rear
right cover. Be sure to install
the paper deck before installing
the original tray (if on the right
side).
29 Lift the hopper assembly as far up as it
goes.
COPYRIGHT © 2001 CANON INC.
Work
FUNC
.
twice to select screen 2.
<M> <S>
INSTALL
AUTO-REG LSNS-KIL
0
REG-APER
to select '1'.
2000 2000 2000 2000
CHAPTER 3 INSTALLATION
<R>
2/4
0
F03-303-13
Stepped screws (face
sticker is attached to
the screw hole
Stepped screws
Original tray
(face sticker is attached
to the screw hole)
Screws
(face sticker is
attached to the
screw hole)
CANON CLC5000 REV.0 JAN. 2001
Remarks
<P> <F>
Original tray
Screws
(face sticker is attached
to the screw hole)
F03-303-14
3-19