Handle Assembly - IBM IntelliStation M Pro Hardware Maintenance Manual

Handle assembly

Before you begin:
v Read "Safety information" on page 129.
v Read "Installation guidelines" on page 31.
v Review the information in "System reliability considerations" on page 31.
To remove the handle cap, complete the following steps:
1. Turn off the computer and all attached devices; then, disconnect all external
2. Use a flat-blade screwdriver to gently press in and down on the tabs on the
3. Lift up on the handle cap to separate it from the handle support.
4. Turn the computer back to the tower-orientation; then, remove the top handle.
To remove the handle support, complete the following steps:
1. Turn off the computer, if it is on.
2. Disconnect the computer power cord.
3. Firmly grasp the handle support, and slide it away from the front bezel.
4. Lift up on the handle support to remove it from the slots in the top of the
cables and power cords. See "Turning off the computer" on page 10.
interior side wall of the handle.
Tab locations
a. Carefully use a flat-blade screwdriver to push in the tabs inside the plastic
cover on the top of the computer; then, remove the plastic cover. Store the
cover for possible future use.
b. Grasp the metal handle, and slide it toward the rear of the computer to
remove it from the computer. Store the metal handle for possible future use.
chassis.
FRU information (service only)
97