Receiving Documents Even When Paper Has Run Out (Memory Reception Function); Rotating Received Data To Fit The Available Paper (Rotate Received Data Function) - Kyocera KM-C2520 Operation Manual

Fax Operation (Names of Parts / Preparations / Features and Functions of this Fax)
In order to perform an F-Code Based Communication, the other party's fax must have F-Code
Based capabilities specific to the communication you are attempting. Therefore, you should
thoroughly discuss in advance with the party you plan to communicate with the capabilities of your
respective models before attempting to transmit or receive using F-Code Based Communications.
Refer to Communicating Using F-Codes (F-Code Based Communication) on page 5-14, for a more
detailed information regarding the F-Code Based Communication capabilities of this fax.

Receiving Documents Even When Paper Has Run Out (Memory Reception function)

When you cannot print out because paper has
run out or a paper jam occurs, the data for all
received documents will be temporarily stored in
memory and will then be printed out
automatically once printing is enabled.
IMPORTANT: If, for any reason, power to the fax is disconnected or lost, data received into memory
may be lost. Ask the other party to retransmit any documents for which data was lost. (Refer to
page 4-2.)

Rotating Received Data to Fit the Available Paper (Rotate Received Data function)

Even if the orientation of the received
documents and of the paper set in the
drawers differs, if their size is the same
(11 × 8
automatically rotate the received data
90° counter-clockwise before printing it
out. No special settings are required to
use this function.
NOTE: If paper of the same size is set in different orientations, depending on the type of
communication that is involved, there are times when rotation of the received data is not possible.
For further information on paper orientation, refer to Paper Size and Priority Feed Chart (Inch
version) on page 10-5, and Paper Size and Priority Feed Chart (Metric version) on page 10-7.
If the transmitting party's TTI information is set to be printed outside the border of the transmitted
page, received data cannot be rotated and the received image will be reduced slightly to enable the
appropriate information to be printed out.
1-18
" [A4]), this function will
1/2