Canceling A Direct Feed Transmission; Canceling A Reception - Kyocera KM-C2520 Operation Manual

Fax Operation (Basic Use)

Canceling a Direct Feed Transmission

A message such as that shown below
will be displayed after dialing the
destination party in the Direct Feed
Transmission mode.
If you want to cancel a Direct Feed
Transmission, press the [Stop] key or
press the Stop/Clear key. The
document that is currently being
scanned will be ejected and the touch
panel will return to the initial mode
settings. If there are any documents left in the Document Processor, remove them from the
Document Processor.

Canceling a Reception

If you want to cancel a reception, perform the following procedure.
1
Press the [Status] ([Act status]) key in
the bottom right of the touch panel. The
status of the communication currently in
progress will appear in the message
display.
2 Press the [Stop] key. The touch panel
will return to the initial mode settings.
NOTE: If you attempt to cancel a reception that is scheduled from multiple transmitting faxes (such
as a Polling Reception) and there were fax machines still remaining to be received from, a message
will appear in the message display asking whether or not you want to continue the receptions from
the remaining faxes. To continue, press the [Yes] key. To stop the receptions, press the [No] key.
2-14
Check Status of Fax
Status of Fax
Port
Doc #: 020.
Dialing.
03.
Stop
for fax transmission.
riginal & assign destination.
TX
Abbrev.
setting
Application
Register
Check Status of Fax
Status of Fax
Port
Receive
Service center
03.
No. of pages
001.
Stop
Print
Memory usage:
OCT-11-2005 16:00
Dest.
check
Re-dial
On-hook
Memory TX
Auto RX
Print Report
Status
Print
Memory
OCT-11
.0%
Memory
OCT-11