Error Code Tables - Kyocera KM-C2520 Operation Manual

Error Code Tables

When a communications error occurs, one of the following error codes will be printed out on the
corresponding Transmission Report or Reception Report as well as the Activity Report.
Refer to the following tables for a more detailed explanation of the error.
NOTE: If an error occurs during communication at a transmission speed of 33600 bps, the 'U' in the
error codes noted below will change to an 'E'.
CODE
Busy
Stopped
U00300
U00420 - U00462
U00600 - U00690
U00700
U00800
U00810
U00900
U00910
U01000 - U01092
U01100 - U01199
U01400
U01500
U01600
U01700
U01720
CAUSE AND/OR PROCEDURE FOR CORRECTION
The line is busy or the other party does not answer after automatically
redialing the set number of times.
Perform transmission or reception procedures again.
Transmission has been interrupted by pressing the Stop/Clear key.
Reception has been interrupted by pressing the Stop/Clear key.
During multiple communication (Broadcast Transmission, Polling
Reception, etc.), this unit was unable to transmit to all destinations due
to a communications interruption.
The destination FAX has run out of recording paper. Check with the
destination party.
Connection was made on a call initiated by the transmitting party, but
the transmission has been interrupted because the transmitting party
does not possess the necessary communication capabilities.
Communication was interrupted due to trouble with your unit. Perform
transmission or reception procedures again.
Communication was interrupted due to trouble with the other party's
FAX unit. Check with the other party.
Unsuccessfully transmitted page(s) remain. Perform transmission
procedures again.
Unsuccessfully received page(s) remain. Perform reception
procedures again.
A communication error occurred during transmission. Perform
transmission procedures again.
A communication error occurred during reception. Perform reception
procedures again.
A communication which uses the timer was scheduled, and a number
was entered using an abbreviated number or one-touch key, etc., but
communication with that party was impossible because that number
was no longer registered when the scheduled time arrived. Check your
unit.
Or, communication with that party was impossible because the
number included a pound sign (#) and it was registered with the Line
Type setting set to "Tone Line", but the Line Type setting had been
changed to "Pulse Line" at the time you attempted that
communication.
A communication error occurred during transmission at high
transmission speed. Perform transmission procedures again.
A communication error occurred during reception at high transmission
speed. Perform reception procedures again after having the
transmitting party lower the transmission speed.
A communication error occurred during transmission at high
transmission speed. Perform transmission procedures again.
Reference Information
10-11