Verifying The (*,G) Forwarding Capability; Verifying The Subnet Entry Support Status; Verifying The Current Replication Mode; Displaying The Replication Mode Auto Detection Status - Cisco WS-SUP32-GE-3B - Supervisor Engine 32 Software Configuration Manual

Chapter 24 Configuring IPv6 Multicast PFC3B Layer 3 Switching

Verifying the (*,G) Forwarding Capability

This example shows how to verify the (*,G) forwarding:
Router# show platform software ipv6-multicast capability | include (\*,G)
(*,G) bridging for IPv6 is supported using FIB

Verifying the Subnet Entry Support Status

This example shows how to verify the subnet entry support status:
Router# show platform software ipv6-multicast capability | include entries
Directly-connected entries for IPv6 is supported using ACL-TCAM.

Verifying the Current Replication Mode

This example shows how to verify the current replication mode:
Router# show platform software ipv6-multicast capability | include Current
Current System HW Replication Mode : Ingress
Enter the no ipv6 mfib hardware-switching replication-mode ingress command to enable replication
Note
mode auto detection.

Displaying the Replication Mode Auto Detection Status

This example shows how to display the replication mode auto detection status:
Router# show platform software ipv6-multicast capability | include detection
Auto-detection of Replication Mode : ON

Displaying the Replication Mode Capabilities

This example shows how to display the replication mode capabilities of the installed modules:
Router# show platform software ipv6-multicast capability | begin ^Slot
Slot Replication-Capability Replication-Mode
1 Ingress
2 Egress
6 Egress
8 Ingress
OL-11439-03
Ingress
Ingress
Ingress
Ingress
Catalyst Supervisor Engine 32 PISA Cisco IOS Software Configuration Guide, Release 12.2ZY
Using show Commands to Verify IPv6 Multicast Layer 3 Switching
24-5