General Tests; Scheduleswitchover; Testfirmwarediagstatus - Cisco WS-SUP32-GE-3B - Supervisor Engine 32 Software Configuration Manual

General Tests

General Tests
These are the general tests:
•
•

ScheduleSwitchover

The ScheduleSwitchover test allows you to trigger a switchover at any time using the online diagnostics
scheduling capability.
Table A-38
Attribute
Disruptive/Nondisruptive
Recommendation
Default
Release
Corrective action
Hardware support

TestFirmwareDiagStatus

The TestFirmwareDiagStatus test displays the results of the power-on diagnostic tests run by the
firmware during the module bootup.
Table A-39
Attribute
Disruptive/Nondisruptive
Recommendation
Default
Release
Corrective action
Hardware support
Catalyst Supervisor Engine 32 PISA Cisco IOS Software Configuration Guide, Release 12.2ZY
A-22
ScheduleSwitchover, page A-22
TestFirmwareDiagStatus, page A-22
ScheduleSwitchover Test Attributes
TestFirmwareDiagStatus Test Attributes
Description
Disruptive.
Schedule this test during downtime to test the ability of the
standby supervisor engine to take over after a switchover.
Off.
12.2(18)ZY
None
Supervisor engines only.
Description
Nondisruptive.
This test can only be run at bootup.
This test runs by default during bootup or after a reset or OIR
12.2(18)ZY
None. See the system message guide.
All modules, including supervisor engines.
Appendix A Online Diagnostic Tests
OL-11439-03