Testipsecencryptdecryptpkt; Stress Tests; Testtrafficstress - Cisco WS-SUP32-GE-3B - Supervisor Engine 32 Software Configuration Manual

Stress Tests

TestIPSecEncryptDecryptPkt

The TestIPSecEncryptDecryptPkt test checks the encryption functionality by exchanging a packet
between the supervisor engine in-band port and the crypto engine of the IPSec services modules
(WS-SVC-IPSEC, SPA-IPSEC) using the switch fabric or bus (whichever is applicable). After several
exchanges, the packet is checked to verify that the original data is preserved after the encryption and
decryption process performed by the crypto engine. The Layer 2 lookup drives the packet between the
supervisor in-band port and the crypto engine.
Table A-34
Attribute
Disruptive/Nondisruptive
Recommendation
Default
Release
Corrective action
Hardware support
Stress Tests
These are the stress tests:
•
•

TestTrafficStress

The TestTrafficStress test stress tests the switch and the installed modules by configuring all of the ports
on the modules into pairs, which then pass packets between each other. After allowing the packets to
pass through the switch for a predetermined period, the test verifies that the packets are not dropped.
Table A-35
Attribute
Disruptive/Nondisruptive
Recommendation
Default
Release
Corrective action
Hardware support
Catalyst Supervisor Engine 32 PISA Cisco IOS Software Configuration Guide, Release 12.2ZY
A-20
TestIPSecEncryptDecryptPkt Test Attributes
TestTrafficStress, page A-20
TestEobcStressPing, page A-21
TestTrafficStress Test Attributes
Description
Nondisruptive. Test runs every minute by default.
This test can only be run at bootup.
This test runs by default during bootup or after a reset or OIR.
12.2(18)ZY.
None. See the system message guide for more information.
VPN services module.
Description
Disruptive. Disruption is several minutes.
Use this test to qualify hardware before installing it in your
network.
Off.
12.2(18)ZY.
Not applicable.
PFC3.
Appendix A Online Diagnostic Tests
OL-11439-03