Displaying Traffic Storm Control Settings - Cisco WS-SUP32-GE-3B - Supervisor Engine 32 Software Configuration Manual

Chapter 36 Configuring Traffic Storm Control
Router(config)# interface gigabitethernet 3/16
Router(config-if)# storm-control multicast level 70.5
Router(config-if)# end
This example shows how the traffic storm control level configured for one mode affects all other modes
that are already configured on the Gigabit Ethernet interface 4/10:
Router# show run inter gig4/10
Building configuration...
Current configuration : 176 bytes
!
Router# interface GigabitEthernet4/10
Router# switchport
Router# switchport mode access
Router# storm-control broadcast level 70.00
Router# storm-control multicast level 70.00
Router# spanning-tree portfast edge
Router# end
Router# configure terminal
Router(config)# interface gigabitethernet 4/10
Router(config-if)# storm-control unicast level 20
Router(config-if)# end
Router# show interfaces gig4/10 counters storm-control
Port
Gi4/10
Router#

Displaying Traffic Storm Control Settings

To display traffic storm control information, use the commands described in
Table 36-1 Commands for Displaying Traffic Storm Control Status and Configuration
Command
Router# show interfaces [{type
{port-channel number}] switchport
Router# show interfaces [{type
{port-channel number}] counters storm-control
Router# show interfaces counters storm-control [module
slot_number]
1. type = ethernet, fastethernet, gigabitethernet, or tengigabitethernet
The show interfaces [{interface_type slot/port} | {port-channel number}] counters command does not
Note
display the discard count. You must use the storm-control keyword to display the discard count.
OL-11439-03
UcastSupp % McastSupp %
20.00 20.00
1
slot/port} |
1
slot/port} |
Catalyst Supervisor Engine 32 PISA Cisco IOS Software Configuration Guide, Release 12.2ZY
Displaying Traffic Storm Control Settings
BcastSupp % TotalSuppDiscards
20.00 0
Purpose
Displays the administrative and operational status of all
Layer 2 LAN ports or the specified Layer 2 LAN port.
Displays the total number of packets discarded for all
three traffic storm control modes, on all interfaces or on
the specified interface.
Table 36-1.
36-5