Configuring Nde On The Pfc3B - Cisco WS-SUP32-GE-3B - Supervisor Engine 32 Software Configuration Manual

Chapter 46 Configuring NDE

Configuring NDE on the PFC3B

These sections describe how to configure NDE on the PFC3B:
•
•
•
Enabling NDE From the PFC3B
To enable NDE from the PFC3B, perform this task:
Command
Router(config)# mls nde sender [version {5 | 7}]
Router(config)# no mls nde sender
Router(config)# no mls nde sender version
Note •
•
This example shows how to enable NDE from the PFC3B:
Router(config)# mls nde sender
This example shows how to enable NDE from the PFC3B and configure NDE version 5:
Router(config)# mls nde sender version 5
Populating Additional NDE Fields
You can configure NDE to populate the following additional fields in the NDE packets:
•
•
•
Not all of the additional fields are populated with all flow masks. See the
page 46-3
OL-11439-03
Enabling NDE From the PFC3B, page 46-11
Populating Additional NDE Fields, page 46-11
Configuring NetFlow Flow Sampling, page 46-12
NDE from the PFC3B uses the source interface configured for the PISA (see the
PISA NDE Source Layer 3 Interface" section on page
NetFlow version 9 is supported and is described at this URL:
http://www.cisco.com/en/US/docs/ios/12_3/feature/gde/nfv9expf.html
IP address of the next hop router
Egress interface SNMP ifIndex
BGP AS
for additional information.
Catalyst Supervisor Engine 32 PISA Cisco IOS Software Configuration Guide, Release 12.2ZY
Purpose
Enables NDE from the PFC3B and (optionally) configures the
NDE version.
Do not use this command to enable version 9 records. Instead,
use ip flow-export version 9, which is explained in the
"Configuring NDE on the PISA" section on page 46-13
Disables NDE from the PFC3B.
Reverts to the default (version 7).
46-13).
Configuring NDE
"Configuring the
"NDE Versions" section on
46-11