Scheduling Online Diagnostics - Cisco WS-SUP32-GE-3B - Supervisor Engine 32 Software Configuration Manual

Configuring Online Diagnostics
Run the exhaustive-memory tests.
Step 5
All modules have exhaustive-memory tests available on them. Because the supervisor engine goes into
an unusable state and must be rebooted after the exhaustive-memory tests, run the tests on all other
modules first. Some of the exhaustive-memory tests can take several hours to complete because of the
large memory size of the modules.
Before running the exhaustive-memory tests, all health-monitoring tests should be disabled on the
module that will run the exhaustive-memory tests because the tests will fail with health monitoring
enabled and the switch will take recovery action. Disable the health-monitoring diagnostic tests by using
the no diagnostic monitor module module test all command.
Perform the exhaustive-memory tests in the following order (you can skip any tests not available for a
particular module):
1.
2.
3.
4.
5.
You must reboot the supervisor engine after running the exhaustive-memory tests before it is operational
again. You cannot run any other tests on the supervisor engine or other modules after running the
exhaustive-memory tests. Do not save the configuration when rebooting as it will have changed during
the tests. You will need to power cycle the modules before they can be operational. After a module comes
back on line, reenable the health-monitoring tests using the diagnostic monitor module module test all
command
To set the bootup diagnostic level, perform this task:
Command
Router# diagnostic ondemand {iteration
iteration_count} | {action-on-error {continue |
stop}[error_count]}
This example shows how to set the on-demand testing iteration count:
Router# diagnostic ondemand iteration 3
Router#
This example shows how to set the execution action when an error is detected:
Router# diagnostic ondemand action-on-error continue 2
Router#

Scheduling Online Diagnostics

You can schedule online diagnostics to run at a designated time of day or on a daily, weekly, or monthly
basis for a specific module. You can schedule tests to run only once or to repeat at an interval. Use the
no form of this command to remove the scheduling.
Catalyst Supervisor Engine 32 PISA Cisco IOS Software Configuration Guide, Release 12.2ZY
51-4
TestFibTcamSSRAM
TestAclQosTcam
TestNetFlowTcam
TestAsicMemory
TestAsicMemory
Chapter 51
Purpose
Configures on-demand diagnostic tests to run, how many
times to run (iterations), and what action to take when errors
are found.
Configuring Online Diagnostics
OL-11439-03