Adding A Description For An Interface - Cisco WS-SUP32-GE-3B - Supervisor Engine 32 Software Configuration Manual

Chapter 7 Configuring Interfaces
To configure the debounce timer on a port, perform this task:
Command
Step 1
Router(config)# interface type
Step 2
Router(config-if)# link debounce
[time debounce_time]
Router(config-if)# no link debounce
Step 3
Router# show interfaces debounce
1. type = ethernet, fastethernet, gigabitethernet, or tengigabitethernet
When configuring the debounce timer on a port, note the following information:
•
•
•
Table 7-2
Table 7-2 Default Port Debounce Timer Delay Times
Port Type
Ports operating at 10 Mpbs or 100 Mbps
Ports operating at 1000 Mpbs or 10 Gbps over copper media
Ports operating at 1000 Mpbs or 10 Gbps over fiber media
WS-X6502-10GE 10-Gigabit ports
1. 10 milliseconds with Release 12.2(18)SXF13 and later releases.
On all 10-Gigabit Ethernet ports, the Debounce Timer Disabled is 10 milliseconds and the Debounce
Note
Timer Enabled is 1 second.
This example shows how to enable the port debounce timer on Fast Ethernet port 5/12:
Router(config)# interface fastethernet 5/12
Router(config-if)# link debounce
Router(config-if)# end
This example shows how to display the port debounce timer settings:
Router# show interfaces debounce | include enable
Fa5/12

Adding a Description for an Interface

You can add a description about an interface to help you remember its function. The description appears
in the output of the following commands: show configuration
interfaces.
OL-11439-03
1
slot/port
The time keyword is supported only on fiber Gigabit Ethernet ports.
You can increase the port debounce timer value in increments of 100 milliseconds up to
5000 milliseconds on ports operating at 1000 Mpbs over copper media.
The debounce timer recognize 10 Gbps copper media and detects media-only changes.
lists the time delay that occurs before notification of a link change.
enable 3100
Catalyst Supervisor Engine 32 PISA Cisco IOS Software Configuration Guide, Release 12.2ZY
Configuring Optional Interface Features
Purpose
Selects the port to configure.
Configures the debounce timer.
Reverts to the default setting.
Verifies the configuration.
Debounce Timer Disabled Debounce Timer Enabled
300 milliseconds
300 milliseconds
1
10 milliseconds
1000 milliseconds
,
show running-config
3100 milliseconds
3100 milliseconds
100 milliseconds
3100 milliseconds
,
and show
7-15