Cisco WS-SUP32-GE-3B - Supervisor Engine 32 Software Configuration Manual page 687

Chapter 40 Configuring PFC QoS Statistics Data Export
Router# show mls qos statistics-export info
QoS Statistics Data Export Status and Configuration information
---------------------------------------------------------------
Export Status : enabled
Export Interval : 250 seconds
Export Delimiter : |
Export Destination : Not configured
QoS Statistics Data Export is enabled on following ports:
---------------------------------------------------------
FastEthernet5/24
QoS Statistics Data export is enabled on following shared aggregate policers:
-----------------------------------------------------------------------------
aggr1M
QoS Statistics Data Export is enabled on following class-maps:
---------------------------------------------------------------
class3
Router#
Configuring PFC QoS Statistics Data Export Destination Host and UDP Port
To configure the PFC QoS statistics data export destination host and UDP port number, perform this task:
Command
Step 1
Router(config)# mls qos statistics-export
destination {host_name | host_ip_address}
{port port_number | syslog
[facility facility_name]
[severity severity_value]}
Router(config)# no mls qos statistics-export
destination
Step 2
Router(config)# end
Step 3
Router# show mls qos statistics-export info
When the PFC QoS data export destination is a syslog server, the exported data is prefaced with a syslog
Note
header.
Table 40-2
Table 40-2
Name
kern
user
mail
daemon
auth
syslog
OL-11439-03
lists the supported PFC QoS data export facility and severity parameter values.
Supported PFC QoS Data Export Facility Parameter Values
Definition
kernel messages
random user-level messages
mail system
system daemons
security/authentication messages
internal syslogd messages
Catalyst Supervisor Engine 32 PISA Cisco IOS Software Configuration Guide, Release 12.2ZY
Configuring PFC QoS Statistics Data Export
Purpose
Configures the PFC QoS statistics data export destination
host and UDP port number.
Clears configured values.
Exits configuration mode.
Verifies the configuration.
Name Definition
cron cron/at subsystem
local0 reserved for local use
local1 reserved for local use
local2 reserved for local use
local3 reserved for local use
local4 reserved for local use
40-7