Configuring Mpls Qos Egress Exp Mutation - Cisco WS-SUP32-GE-3B - Supervisor Engine 32 Software Configuration Manual

Configuring MPLS QoS
This example shows how to display a MPLS QoS policy map class summary:
Router# show mls qos mpls
QoS Summary [MPLS]:
-------------------------------------------------------------------------------
Displaying the Configuration of All Classes
To display the configuration of all classes configured for all service policies on the specified interface,
perform this task:
Command
Router# show policy interface interface_type
interface_number
This example shows the configurations for all classes on Fast Ethernet interface 3/27:
Router# show policy interface fastethernet 3/27
FastEthernet3/27
Service-policy input: ip2tag

Configuring MPLS QoS Egress EXP Mutation

These sections describe how to configure MPLS QoS egress EXP mutation:
•
•
Catalyst Supervisor Engine 32 PISA Cisco IOS Software Configuration Guide, Release 12.2ZY
39-28
(* - shared aggregates, Mod - switch module)
Int Mod Dir Class-map DSCP
Fa3/27 5 In exp3
All 5 - Default
class-map: iptcp (match-all)
Match: access-group 101
police :
1000000 bps 1000000 limit 1000000 extended limit
Earl in slot 5 :
0 bytes
5 minute offered rate 0 bps
aggregate-forwarded 0 bytes action: set-mpls-exp-imposition-transmit
exceeded 0 bytes action: drop
aggregate-forward 0 bps exceed 0 bps
class-map: class-default (match-any)
Match: any
Class-map: class-default (match-any)
0 packets, 0 bytes
5 minute offered rate 0 bps, drop rate 0 bps
Match: any
Configuring Named EXP Mutation Maps, page 39-29
Attaching an Egress EXP Mutation Map to an Interface, page 39-29
Agg Trust Fl AgForward-By
Id Id
0 2 dscp 0
0 0* No 0 3466140423
Purpose
Displays the configuration of all classes configured for all
policy maps on the specified interface.
Chapter 39 Configuring MPLS QoS
AgPoliced-By
0 0
0
OL-11439-03