Cisco WS-SUP32-GE-3B - Supervisor Engine 32 Software Configuration Manual page 683

Chapter 40 Configuring PFC QoS Statistics Data Export
% Warning: Export destination not set.
% Use 'mls qos statistics-export destination' command to configure the export destination
Router# show mls qos statistics-export info
QoS Statistics Data Export Status and Configuration information
---------------------------------------------------------------
Export Status : enabled
Export Interval : 300 seconds
Export Delimiter : |
Export Destination : Not configured
Router#
You must enable PFC QoS statistics data export globally for other PFC QoS statistics data export
Note
configuration to take effect.
Enabling PFC QoS Statistics Data Export for a Port
To enable PFC QoS statistics data export for a port, perform this task:
Command
Step 1
Router(config)# interface type
Step 2
Router(config-if)# mls qos statistics-export
Router(config-if)# no mls qos statistics-export
Step 3
Router(config)# end
Step 4
Router# show mls qos statistics-export info
1. type = ethernet, fastethernet, gigabitethernet, or tengigabitethernet
This example shows how to enable PFC QoS statistics data export on FastEthernet port 5/24 and verify
the configuration:
Router# configure terminal
Router(config)# interface fastethernet 5/24
Router(config-if)# mls qos statistics-export
Router(config-if)# end
Router# show mls qos statistics-export info
QoS Statistics Data Export Status and Configuration information
---------------------------------------------------------------
Export Status : enabled
Export Interval : 300 seconds
Export Delimiter : |
Export Destination : Not configured
QoS Statistics Data Export is enabled on following ports:
---------------------------------------------------------
FastEthernet5/24
Router#
When enabled on a port, PFC QoS statistics data export contains the following fields, separated by the
delimiter character:
•
•
•
•
OL-11439-03
1
slot/port
Export type ("1" for a port)
Slot/port
Number of ingress packets
Number of ingress bytes
Catalyst Supervisor Engine 32 PISA Cisco IOS Software Configuration Guide, Release 12.2ZY
Configuring PFC QoS Statistics Data Export
Purpose
Selects the interface to configure.
Enables PFC QoS statistics data export for the port.
Disables PFC QoS statistics data export for the port.
Exits configuration mode.
Verifies the configuration.
40-3