Cisco WS-SUP32-GE-3B - Supervisor Engine 32 Software Configuration Manual page 635

Chapter 38 Configuring PFC QoS
The difference between this policer configuration and the marking configuration is the policy-map action
statements. The marking example uses the set dscp command to mark the traffic with a particular DSCP
value. This policing example marks the CLASSIFY-OTHER traffic to a DSCP value of zero and polices
that traffic to 50 Mbps. To do this, replace the set dscp command with a police command. The police
command allows a marking action to take place: it marks all traffic below the 50 Mbps limit to DSCP 0
and drops any traffic above the 50 Mbps threshold.
This is the modified IPPHONE-PC policy map, which includes the police command:
policy-map IPPHONE-PC
class CLASSIFY-OTHER
police 50000000 1562500 conform-action set-dscp-transmit default exceed-action drop
These are the police command parameters:
The 50000000 parameter defines the committed information rate (CIR) for traffic allowed in this
•
traffic class. This example configures the CIR to be 50 Mbps.
The 1562500 parameter defines the CIR burst size for traffic in this traffic class; this example uses
•
a default maximum burst size. Set the CIR burst size to the maximum TCP window size used on the
network.
• The conform action keywords define what the policer does with CLASSIFY-OTHER packets
transmitted when the traffic level is below the 50Mbps rate. In this example, set-dscp-transmit
default applies DSCP 0 to those packets.
The exceed action defines what the policer does with CLASSIFY-OTHER packets transmitted when
•
the traffic level is above the 50 Mbps CIR. In this example, exceed action drop drops those packets.
This is a basic example of a single rate per-interface aggregate policer. The PFC3 supports a dual-rate
policer for providing both CIR and peak information rate (PIR) granularity.
Attach the policy map to the appropriate interface using the service-policy input command:
interface FastEthernet5/1
service-policy input IPPHONE-PC
To monitor the policing operation, use these commands:
show policy-map interface fastethernet 5/1
show class-map
show mls qos ip fastethernet 5/1
OL-11439-03
Catalyst Supervisor Engine 32 PISA Cisco IOS Software Configuration Guide, Release 12.2ZY
Common QoS Scenarios
38-101