Configuring A Range Of Interfaces - Cisco WS-SUP32-GE-3B - Supervisor Engine 32 Software Configuration Manual

Configuring a Range of Interfaces

To begin configuring Fast Ethernet port 5/5, enter the interface keyword, interface type, and slot
Step 5
number/port number at the privileged EXEC prompt, as shown in the following example:
Router# configure terminal
Enter configuration commands, one per line.
Router(config)# interface fastethernet 5/5
Router(config-if)#
Note
After each interface command, enter the interface configuration commands your particular interface
Step 6
requires.
The commands you enter define the protocols and applications that will run on the interface. The
commands are collected and applied to the interface command until you enter another interface
command or press Ctrl-Z to get out of interface configuration mode and return to privileged EXEC
mode.
Step 7 After you configure an interface, check its status by using the EXEC show commands listed in
"Monitoring and Maintaining Interfaces" section on page
Configuring a Range of Interfaces
The interface-range configuration mode allows you to configure multiple interfaces with the same
configuration parameters. After you enter the interface-range configuration mode, all command
parameters you enter are attributed to all interfaces within that range until you exit out of the
interface-range configuration mode.
To configure a range of interfaces with the same configuration, perform this task:
Command
Router(config)# [no] interface range
{{vlan vlan_ID - vlan_ID [, vlan vlan_ID - vlan_ID]}
1
| {type slot/port - port [, type
| {macro_name [, macro_name]}}
1. type = ethernet, fastethernet, gigabitethernet, or tengigabitethernet
When configuring a range of interfaces, note the following information:
•
•
•
•
•
•
Catalyst Supervisor Engine 32 PISA Cisco IOS Software Configuration Guide, Release 12.2ZY
7-4
You do not need to add a space between the interface type and interface number. For example,
in the preceding line you can specify either fastethernet 5/5 or fastethernet5/5.
1
slot/port - port]}
For information about macros, see the
page 7-5.
You can enter up to five comma-separated ranges.
You are not required to enter spaces before or after the comma.
You do not need to add a space between the interface numbers and the dash when using the
interface range command.
The no interface range command supports VLAN interfaces.
The interface range command supports VLAN interfaces for which Layer 2 VLANs have not been
created with the interface vlan command.
End with CNTL/Z.
7-16.
Purpose
Selects the range of interfaces to be configured.
"Defining and Using Interface-Range Macros" section on
Chapter 7 Configuring Interfaces
OL-11439-03