Cisco WS-SUP32-GE-3B - Supervisor Engine 32 Software Configuration Manual page 688

Configuring PFC QoS Statistics Data Export
Table 40-2
Name
lpr
news
uucp
Table 40-3
Table 40-3
Severity Parameter
Name
emerg
alert
crit
err
warning 4
notice
info
debug
This example shows how to configure 172.20.52.3 as the destination host and syslog as the UDP port
number and verify the configuration:
Router# configure terminal
Router(config)# mls qos statistics-export destination 172.20.52.3 syslog
Router(config)# end
Router# show mls qos statistics-export info
QoS Statistics Data Export Status and Configuration information
---------------------------------------------------------------
Export Status : enabled
Export Interval : 250 seconds
Export Delimiter : |
Export Destination : 172.20.52.3, UDP port 514 Facility local6, Severity debug
QoS Statistics Data Export is enabled on following ports:
---------------------------------------------------------
FastEthernet5/24
QoS Statistics Data export is enabled on following shared aggregate policers:
-----------------------------------------------------------------------------
aggr1M
QoS Statistics Data Export is enabled on following class-maps:
---------------------------------------------------------------
class3
Catalyst Supervisor Engine 32 PISA Cisco IOS Software Configuration Guide, Release 12.2ZY
40-8
Supported PFC QoS Data Export Facility Parameter Values (continued)
Definition
line printer subsytem
netnews subsytem
uucp subsystem
lists the supported PFC QoS data export severity parameter values.
Supported PFC QoS Data Export Severity Parameter Values
Number Definition
0 system is unusable
1 action must be taken immediately
2 critical conditions
3 error conditions
warning conditions
5 normal but significant condition
6 informational
7 debug-level messages
Chapter 40 Configuring PFC QoS Statistics Data Export
Name Definition
local5 reserved for local use
local6 reserved for local use
local7 reserved for local use
OL-11439-03