Configuration Examples For The Database Agent - Cisco WS-SUP32-GE-3B - Supervisor Engine 32 Software Configuration Manual

Chapter 34 Configuring DHCP Snooping
Command
Router# renew ip dhcp snooping database [validation
none] [url]
Router# ip dhcp snooping binding mac_address vlan
vlan_ID ip_address interface ifname expiry
lease_in_seconds
Router# no ip dhcp snooping binding mac_address vlan
vlan_ID ip_address interface ifname
When configuring the DHCP snooping database agent, note the following information:
•
•
•

Configuration Examples for the Database Agent

These sections provide examples for the database agent:
•
•
•
Example 1: Enabling the Database Agent
The following example shows how to configure the DHCP snooping database agent to store the bindings
at a given location and to view the configuration and operating state:
Router# configure terminal
Router(config)# ip dhcp snooping database tftp://10.1.1.1/directory/file
Router(config)# end
Router# show ip dhcp snooping database detail
Agent URL : tftp://10.1.1.1/directory/file
Write delay Timer : 300 seconds
Abort Timer : 300 seconds
Agent Running : No
Delay Timer Expiry : 7 (00:00:07)
Abort Timer Expiry : Not Running
Last Succeded Time : None
Last Failed Time : 17:14:25 UTC Sat Jul 7 2001
Last Failed Reason : Unable to access URL.
Total Attempts
Successful Transfers :
Successful Reads
Successful Writes
Media Failures
First successful access: Read
OL-11439-03
Store the file on a TFTP server to avoid consuming storage space on the switch storage devices.
When a switchover occurs, if the file is stored in a remote location accessible through TFTP, the
newly active supervisor engine can use the binding list.
Network-based URLs (such as TFTP and FTP) require that you create an empty file at the configured
URL before the switch can write the set of bindings for the first time.
Example 1: Enabling the Database Agent, page 34-13
Example 2: Reading Binding Entries from a TFTP File, page 34-14
Example 3: Adding Information to the DHCP Snooping Database, page 34-16
:
:
:
:
Catalyst Supervisor Engine 32 PISA Cisco IOS Software Configuration Guide, Release 12.2ZY
Purpose
(Optional) Requests the read entries from a file at the given
URL.
(Optional) Adds bindings to the snooping database.
(Optional) Deletes bindings to the snooping database.
21 Startup Failures :
0 Failed Transfers :
0 Failed Reads :
0 Failed Writes :
0
Configuring DHCP Snooping
0
21
0
21
34-13