Table of Contents
Advertisement
Note: For proper airflow, you must replace the hard drive carrier in the server system, even if no
hard drive is installed in it.
8. When the black lever begins to close by itself, push on it to lock the drive carrier
into place.
9. Install the server system cover. For instructions, see
Cover".
10. (Optional) Install the front bezel. For instructions, see
11. Plug all peripheral devices and the AC power cable into the server.
Installing or Removing a Slimline Optical Drive
(SR1530SH)
Caution: The optical drive is NOT hot-swappable. Before removing or replacing the optical drive,
you must first take the server out of service, turn off all peripheral devices connected to
the system, turn off the system by pressing the power button, and unplug the AC power
cord from the system or wall outlet.
Installing a Slimline Optical Drive
Notes:
•
If you are replacing an optical drive, see
page 49
1. Observe the safety and ESD precautions at the beginning of this book. See
Information" on page
2. Power down the server and unplug all peripheral devices and the AC power cable.
3. Remove the server system cover. For instructions, see
System Cover" on page
4. If it is installed, remove the bezel. For instructions, see
Bezel" on page
5. Note the orientation of the PCI cooling fan located behind the optical drive bay,
then disconnect the fan cable (see letter "A" in
mounting pegs (see letter "B" in
46
for instructions first. Return to these steps when directed.
iii.
24.
22.
Intel
"Installing the Server System
"Installing the Front
"Removing a Slimline Optical Drive" on
"Removing the Server
Figure
38) and lift the fan from the
Figure
38).
®
Server System SR1530SH/SR1530HSH User's Guide
Bezel".
"Safety
"Removing the Front
Advertisement
Table of Contents
