Configuration Jumpers; Figure 9. Configuration Jumper Descriptions - Intel SR1530HSH - Server System - 0 MB RAM User Manual

Configuration Jumpers

BIOS
Recovery
2
J1E1
3
Remove jumper for BIOS recovery
Password
Clear 2
J1E2
3
CMOS
Clear
2
J1E3
3
Jumper Name
BIOS Recovery
Password Clear
CMOS Clear
®
Intel Server System SR1530SH/SR1530HSH User's Guide
®
Intel 82566 E NIC Controller
®
Intel 82541 NIC
Serial
Port
Default
External
Default
USB
Update
Internal
USB
SATA 3
SATA 5
Default
IPMB
SATA 4
CLEAR
HSBP
CMOS
Front Panel
Header
SATA 1
SATA 2 SATA 0 Floppy
A
Jumper in normal position (pins 1-2) allows normal system
operation with correct BIOS settings. System will POST normally.
Jumper in maintenance mode (pins 2-3) allows Intel
password reset.
Jumper removed is used to recover from a corrupted BIOS.
Bootable media with a valid BIOS ROM required.
Jumper in normal position (pins 1-2) allows the system to
successfully POST and boot to the operating system environment.
BIOS settings are kept intact.
Jumper in clear position (pins 2-3) initiates a clearing of password.
Jumper in normal position (pins 1-2) allows the system to
successfully POST and boot to the operating system environment.
BIOS settings are kept intact.
Jumper in clear position (pins 2-3) initiates a clearing of NVRAM
following POST. A system message confirms the CMOS clear
operation was successful. This setting enforces default BIOS
settings, which you can change by entering setup pressing F2, then
exiting setup pressing F10 and saving changes.

Figure 9. Configuration Jumper Descriptions

Note: Refer to the Technical
Diagnostic
BIT 1 BIT 2
Product Specification for
LEDs
LSB MSB Diagnostic LED decoder list.
NIC 2
NIC 1 Serial
USB VGA
USB
SysFan 1
CPUFan 1
CPU Socket
A
Main
Power
SysFan 4
SysFan 3
SysFan 2
Jumper Purpose
NIC LED Functions
LED Color LED State NIC State
MS
Off LAN link is not established.
KB
Left Green On LAN link is established.
Blinking LAN activity is occurring.
10 Mbit/sec data rate is selected.
N/A Off
Right Green On 100 Mbit/sec data rate is selected.
CPU Power
Yellow On
1000 Mbit/sec data rate is selected.
®
AMT setting/
13