Removing Dimms - Intel SR1530HSH - Server System - 0 MB RAM User Manual

9. When the DIMM is correctly positioned, push down on the top edge of the DIMM
until the retaining clips snap into place.
10. Make sure the clips are firmly in place. See letter "D" in Figure 21.
11. Install the server system cover. For instructions, see
Cover".

Removing DIMMs

To remove a DIMM, follow these steps:
1. Observe the safety and ESD precautions at the beginning of this book. See
Information" on page
2. Power down the server and unplug all peripheral devices and the AC power cable.
3. Remove the server system cover. For instructions, see
System Cover" on page
4. Locate the DIMM sockets. See
5. Gently spread the retaining clips at each end of the socket. The DIMM lifts from
the socket.
6. Holding the DIMM by the edges, lift it from the socket, and store it in an anti-static
package.
7. Install the server system cover. For instructions, see
Cover".
32
iii.
24.
Figure 21.
®
Intel Server System SR1530SH/SR1530HSH User's Guide
"Installing the Server System
"Removing the Server
"Installing the Server System
"Safety