Configuring The Logging Options; Local Logging Config - Cisco Small Business Pro SA 520W Administration Manual

Administration

Configuring the Logging Options

STEP 2
STEP 3
Configuring the Logging Options
NOTE
Cisco SA 500 Series Security Appliances Administration Guide
Enter the following information:
• Date/Time: Choose the time zone relative to Greenwich Mean Time (GMT).
• Automatically Adjust for Daylight Savings Time: Check this box if you want
the time to be automatically adjusted for Daylight Savings Time.
• Use Default NTP Servers or Use Custom NTP Servers: You can use the
default Network Time Protocol (NTP) servers, or you can enter the IP
addresses of up to two custom NTP servers.
Click Apply to save your settings, or click Reset to revert to the saved settings.
You can configure logs for various events that occur on your network. Refer to the
following topics:
•

Local Logging Config

• IPv6 Logging
• Remote Logging
• Logs Facility
For information about viewing the system event logs, IPsec VPN Logs, and Policy
Enforcement Logs, see
Local Logging Config
You can configure the router to log events such as unicast or broadcast traffic
passing through the router, or packets that are dropped due to source MAC
filtering.
Enabling logging options can generate a significant volume of log messages and is
recommended for debugging purposes only.
View Logs Status, page 46.
9
201