3-16
Options
SIMM Installation
Install SIMM sticks into the system board as follows. Locate the SIMM sockets using
Figure Section 3-10.
Remove the top cover and any expansion boards covering the socket as previ-
1.
ously described.
Insert the SIMM into the SIMM socket at an angle, then push the SIMM upright
2.
so that the clips hold the SIMM in place (see Figure Section 3-13).
1 of 2
Clips
3.
Repeat steps 2 for each SIMM to be installed.
Replace any removed expansion boards.
4.
Replace the top cover and run Setup to reconfigure the computer for the addi-
5.
tional memory (see Section 2, Setup and Operation).
Figure Section 3-13 SIMM Installation