System Board Removal; Power Supply Screws - NEC POWERMATE P60D Service Manual

5. Remove the four screws holding the power supply to the system unit (see
Figure Section 5-25).
6. Slide the power supply toward the system board to release the two tabs at the
front, then lift it out of the system unit.
1 of 2
Tabs

System Board Removal

Remove the system board per Figure Section 5-27 and the following steps.
Remove the following components as previously described.
1.
n
top cover
n
expansion slot boards
n
ISA/PCI-Bus backboard
n
3 1/2-inch drive bracket
n
SIMMs installed on the system board
Figure Section 5-25 Power Supply Screws
NOTE: Remove the optional video DRAM
chips if installed, see Section 3, Options.
Desktop Repair
Power Supply
Screws
5-15