Table Section 2-4 Peripheral Management Setup Parameters
Parameter
Options
Second Serial
Disabled
Port Address
2F8H
2E8H
Parallel Port
Disabled
Address
378H
278H
3BCH
Parallel Port
Normal
Mode
Extended
EPP
Configure With BIOS Defaults
This menu option opens a screen that loads the BIOS setup default values from the ROM
table. Type
y
to load the values or
Configure With Power-On Defaults
Selecting this menu option opens a screen that loads the power-on default values from the
ROM table. Type
y
if to load the values or
Change Password
This menu option opens a screen that sets, change or delete a password. Once a password is
set, the Setup program cannot be entered without entering the password.
To set a password, do the following:
Highlight the "Change Password" selection on the Main Menu.
1.
2.
Press
Enter
3.
Type in the password using up to six ASCII characters.
Press
4.
Enter
message appears on the screen.
Press
5.
Enter
Description
Default is Disabled. The address is automatically set to 2F8H
in the Programming Option, above.
Default is Disabled. The address is automatically set to 378H
in the Programming Option, above.
Default is Normal. The Normal option sets the port to operate
in the AT-compatible mode. Selecting Extended sets the port
to operate in the bi-directional PS/2-compatible mode.
n
to not load the values, then press
. An "Enter NEW Password" message appears on the screen.
. Reenter the password to confirm it. A "Password Now Enabled"
. Setup returns to the Main Menu. The password is now in effect.
Setup and Operation
n
to not load the values, then press
2-15
Enter
.
Enter
.