Peripheral Management Setup; Peripheral Management Setup Parameters - NEC POWERMATE P60D Service Manual

2-14 Setup and Operation
Table Section 2-2 Advanced CMOS Setup Parameters
Parameter Options
Enhanced ISA Disabled or
Timing Enabled
ISA IRQ 9 Free or
ISA IRQ 10 Used
ISA IRQ 11

Peripheral Management Setup

This menu sets or modifies the peripheral options associated with the I/O controller of the
system, as outlined in Table Section 2-4.
Selection of a parameter is with the keyboard arrow keys or
PgDn to modify the parameter. Press
Pressing F1 opens a small window listing the options available for the selected parameter.
Pressing F5 reverts any changed values back to the original values. Pressing
parameters to the BIOS setup defaults. Pressing
defaults.
Table Section 2-4 Peripheral Management Setup Parameters
Parameter Options
Programming Auto
Option Manual
On-Board Floppy Enabled
Drive Disabled
On-Board IDE Enabled
Drive Disabled
First Serial Port Disabled
Address 3F8H
3E8H
Description
Disabled is the default setting. Selecting Enabled allows
the ISA bus to run at 10 MHz, instead of the standard
8 MHz, if the ISA agents tolerate 10 MHz.
Free is the default setting. Select Used if the system
contains an ISA agent that uses this interrupt. The PCI
auto-configuration code checks this entry and may
attempt to use the interrupt if free.
Esc
CAUTION: Incorrect settings can cause the
system to malfunction.
Description
The Auto setting (default) automatically sets the peripherals
during power up. With Auto selected, the following parameters
are disabled; the values shown are the last manual settings.
Selecting Manual accesses and changes the parameters.
Default is disabled.
Default is Disabled. This disables both the ISA and PCI on-
board peripherals.
Default is Disabled. The address is automatically set to 3F8H
in the Programming Option, above.
Enter
to exit back to the Main Menu.
F7 changes the parameters to the power-on
key. Press PgUp or
F6 changes the