Finishing Desktop 5 1/4-Inch Device Installation; Minitower 5 1/4-Inch Device Installation; Desktop Hard Disk Drive Cables - NEC POWERMATE P60D Service Manual

2. Locate one of the larger power connectors coming from the power supply and
plug it into the hard disk drive power connector (see Figure Section 3-32).
Figure Section 3-32 Desktop Hard Disk Drive Cables

Finishing Desktop 5 1/4-Inch Device Installation

Replace the assemblies removed earlier and reconfigure the system as follows.
1. Reinstall the 3 1/2-inch drive bracket by reversing the steps of the "Desktop
3 1/2-inch Drive Bracket Removal" procedure given earlier.
Replace the top cover and run Setup to reconfigure the computer for the hard
2.
disk drive (see Section 2, Setup and Operation). If a fault occurs at power-on,
verify that the reassembly was performed correctly.
Reconfigure the computer for the hard disk drive by selecting hard disk drive
"Installed" in Setup. Setup will automatically detect the hard disk type. When
installing a hard disk drive that cannot be detected, use the "Define Hard Disk
Type" to determine the hard disk drive type.

MINITOWER 5 1/4-INCH DEVICE INSTALLATION

To install a 5 1/4-inch device into the minitower system, the top cover and 5 1/4-inch blank
panel must first be removed. "Desktop 5 1/4-inch Device Installation" instructions were
provided earlier in this section. When device option kits come with rails preattached,
remove the drive rails and reuse the screws to secure the drives to the drive bracket.
IDE
Cable
Options 3-29
Power
Cable