Finishing Minitower 5 1/4-Inch Device And 3 1/2-Inch Drive Installation - NEC POWERMATE P60D Service Manual

3-38 Options

Finishing Minitower 5 1/4-Inch Device and 3 1/2-Inch Drive Installation

Replace the assemblies removed earlier and reconfigure the system as follows.
1. Reinstall the 5 1/4-inch device or 3 1/2-inch drive cage by reversing the steps of
the procedures given earlier.
n
Align the cage mounting holes screws holes.
n
Secure the back of the cage the chassis with the previously removed screws.
Replace the top cover and connect external peripherals and power cables.
2.
3. Run Setup to reconfigure the computer for the hard disk drive (see Section 2,
Setup and Operation). If a fault occurs at power-on, verify that the reassembly
was performed correctly.
Reconfigure the computer for the hard disk drive by selecting hard disk drive "In-
stalled" in Setup. Setup will automatically detect the hard disk type. When in-
stalling a hard disk drive that cannot be detected, use the "Define Hard Disk
Type" to determine the hard disk drive type.