Hard Disk Drives; Fd1158C, 1.2-Mb Diskette Drive - NEC POWERMATE P60D Service Manual

3-22 Options
Terminating Resistor
Jumper
Not Used
3
2
Drive Address
1 (0, 1, 2, 3)
0
Signal Connector
Figure Section 3-18 FD1158C, 1.2-MB Diskette Drive

Hard Disk Drives

There are two IDE interface connectors on the system board. One system board IDE con-
nector provides a PCI-bus interface. The other system board IDE connector provides the
standard IDE interface. In configurations where the 3 1/2-inch hard disk drive is shipped
with the system unit the PCI-bus IDE connector is used.
When installing a second hard disk drive, use the open IDE connector on the cable coming
from the PCI-bus IDE connector system board IDE connector. The standard IDE connector
on the system board is used when adding a third and fourth IDE hard disk drive. A hard
disk controller board is not required. The IDE drives described in this section are thin-
height (1-inch x 3 1/2-inch) drives. See the 5 1/4-inch device installation instructions later in
this section.
Power Connector
PCB (connectors and jumpers are
attached to back of PCB)
Front
of Drive