3-34
Options
Minitower 3 1/2-Inch Drive Cage Removal
Remove the 3 1/2-inch drive cage as follows.
1.
Remove the top cover as previously described.
Remove the three screws holding the drive cage to the rear of the chassis (see
2.
Figure Section 3-42).
Remove the two screws holding the drive cage to the chassis support bracket (see
3.
Figure Section 3-42).
Screws
Figure Section 3-42 Removing 3 1/2-Inch Drive Cage Screws
Label and unplug the power and signal cables attached to any drive already in-
4.
stalled drive cage. Remove the 3 1/2-inch drive cage from the chassis.
3 1/2-Inch
Drive Cage
Chassis Support
Bracket
Bracket
Screws