SIMM Installation
Install SIMM sticks into the system board as follows. Locate the SIMM sockets using
Figure Section 3-20.
Remove the top cover and any expansion boards covering the socket as previ-
1.
ously described.
Remove the four 3 1/2-inch drive bracket screws (see Figure Section 3-24).
2.
3.
Without removing the power and signal cables, place the 3 1/2-inch bracket with
the diskette drive and hard disk drive attached on the power supply.
3 1/2-Inch
Drive Bracket
Figure Section 3-24 3 1/2-Inch Drive Bracket Screws
Insert the SIMM into the SIMM socket at an angle, then push the SIMM upright
4.
so that the clips hold the SIMM in place (see Figure Section 3-26).
1 of 2
Clips
Four Screws
Figure Section 3-26 SIMM Installation
Power Supply
Options
3-17