Minitower Expansion Board Installation - NEC POWERMATE P60D Service Manual

3-8 Options

Minitower Expansion Board Installation

Install expansion boards into the minitower system unit as follows.
Remove the bottom cover as previously described.
1.
Remove the expansion slot screw and cover (see Figure Section 3-16). Save the
2.
expansion slot cover in the event the expansion board is removed in the future.
PCI Slot
PCI/ISA
Shared
Slot
ISA Slots
Note: Shown with bottom access cover removed.
Figure Section 3-16 Minitower Expansion Slots
3. Install the expansion board into an expansion slot connector. When installing a
full-size expansion board, make sure that the expansion board slides into the guide
rail at the front of the system unit.
4. Reinstall the expansion slot screw to secure the expansion board.
Connect any expansion board cables.
5.
Replace the top cover.
6.
PCI
PCI
Connector 1 Connector 2
ISA/PCI-BUS
Backboard
ISA Connectors