Desktop Blank Panel Removal; Indicator Panel Connectors - NEC POWERMATE P60D Service Manual

Desktop Blank Panel Removal

Remove the front panel assembly from the desktop chassis as follows.
1. Remove the desktop cover and 3 1/2-inch diskette drive bracket as previously
described.
Unplug the following cables from their connectors (see Figure Section 3-24).
2.
n
Power lamp (connector J32)
n
Hard disk drive busy lamp (connector J33)
n
Reset button (connector J31)
3. Remove the five front panel screws (see Figure Section 3-24).
Feed the lamp and reset cables through the hole in the front of system unit chassis
4.
when removing the front panel assembly.
Lamp and
Reset Button
Connectors
(not shown)
Figure Section 3-24 Indicator Panel Connectors
Front Panel
Five Screws
(behind front panel)
Options 3-25
Blank Panel