Optional 5 1/4-Inch Device Removal; Inch Device Screws - NEC POWERMATE P60D Service Manual

5-12 Desktop Repair

Optional 5 1/4-Inch Device Removal

Remove an optional 5 1/4-inch device from the 5 1/4-inch device cage per Figure Section 5-
19, and the following steps.
1. Remove the top cover, front panel, and 3 1/2-inch drive bracket as previously
described.
Unplug all signal and power cables from the device(s) in the 5 1/4-inch device
2.
cage (see Figure Section 5-19).
Remove the four device screws; two from each side of the 5 1/4-inch device cage
3.
(see Figure Section 5-19).
Remove the device out of the 5 1/4-inch device cage from the front of the
4.
system unit.
NOTE: When reinstalling the 5 1/4-inch device,
note that all power cables are keyed to fit only in
the correct position. The red edge of the diskette
drive signal cable is positioned as shown.
2 of 4
Device Screws
Figure Section 5-19 5 1/4-Inch Device Screws
Power Cable
Signal Cable
Device Cage