Introduction
Component Description
Antennas
The access point includes two antennas for wireless
communications. The signal transmitted from both antennas is
identical, but only the best signal received on one of the antennas
is used. The antennas transmit the outgoing signal as a toroidal
sphere, so the antennas should be adjusted to different angles to
provide better coverage. For further information, see "Positioning
the Antennas" on page 2-3.
LED Indicators
The access point includes
three status LED indicators,
as described in the following
figure and table.
LED
PWR
LAN
1-4
Status
Off
On Green
On Amber
Blinking
Green (Slow)
Off
On/Flashing
Green
On/Flashing
Amber
Power
Ethernet
Link/Activity
Description
No power.
Power on and ready for operation.
H/W error or system error.
Indicates one of the following:
• running the power-on self-test
• loading new software
Indicates no valid Ethernet cable link on
the RJ-45 port, or that the port has been
administratively disabled
Indicates a valid 100 Mbps link on the
RJ-45 port. Flashing indicates activity.
Indicates a valid 10 Mbps link on the
RJ-45 port. Flashing indicates activity.
LAN
WLAN
802.11g
Wireless
Link/Activity