SMC Networks 2552W-G User Manual page 92

System Configuration
changes. To use this feature you must define the month and date
to begin and to end the change from standard time. During this
period the system clock is set back by one hour.
CLI Commands for SNTP – To enable SNTP support on the
access point, from the global configuration mode specify SNTP
server IP addresses using the sntp-server ip command, then
use the sntp-server enable command to enable the service. Use
the sntp-server timezone command to set the time zone for your
location, and the sntp-server daylight-saving command to set
daylight savings. To view the current SNTP settings, use the
show sntp command.
SMC-AP(config)#sntp-server ip 10.1.0.19
SMC-AP(config)#sntp-server enable
SMC-AP(config)#sntp-server timezone +8
SMC-AP(config)#sntp-server daylight-saving
Enter Daylight saving from which month<1-12>: 3
and which day<1-31>: 31
Enter Daylight saving end to which month<1-12>: 10
and which day<1-31>: 31
SMC-AP(config)#exit
SMC-AP#show sntp
SNTP Information
=========================================================
Service State
SNTP (server 1) IP
SNTP (server 2) IP
Current Time
Time Zone
Daylight Saving
31th
=========================================================
SMC-AP#
5-38
: Enabled
: 137.92.140.80
: 192.43.244.18
: 19 : 35, Jan 10th, 2004
: +8 (TAIPEI, BEIJING)
: Enabled, from Mar, 31th to Oct,
6-28
6-29
6-32
6-31
6-32