System Configuration
Upgrading Firmware
You can upgrade new SMC2552W-G software from a local file on
the management workstation, or from an FTP or TFTP server.
New software may be provided periodically on SMC's web site
(http://www.smc.com).
After upgrading new software, you must reboot the
SMC2552W-G to implement the new code. Until a reboot occurs,
the SMC2552W-G will continue to run the software it was using
before the upgrade started. Also note that rebooting the access
point with new software will reset the configuration to the factory
default settings.
Before upgrading new software, verify that the SMC2552W-G is
connected to the network and has been configured with a
compatible IP address and subnet mask.
5-30