System Configuration
CLI Commands for System Logging – To enable logging on the
access point, use the logging on command from the global
configuration mode. The logging level command sets the
minimum level of message to log. Use the logging console
command to enable logging to the console. Use the logging host
command to specify up to four Syslog servers. The CLI also
allows the logging facility-type command to set the facility-type
number to use on the Syslog server. To view the current logging
settings, use the show logging command.
SMC-AP(config)#logging on
SMC-AP(config)#logging level alert
SMC-AP(config)#logging console
SMC-AP(config)#logging host 1 10.1.0.3 514
SMC-AP(config)#logging facility-type 19
SMC-AP(config)#exit
SMC-AP#show logging
Logging Information
============================================
Syslog State
Logging Host State
Logging Console State
Server Domain name/IP
Logging Level
Logging Facility Type
=============================================
SMC-AP#
5-36
: Enabled
: Enabled
: Enabled
: 1 10.1.0.3
: Error
: 16
6-24
6-26
6-25
6-24
6-27
6-27