Table of Contents
Advertisement
CLI Commands for WPA Pre-shared Key Security – From the
802.11g interface configuration mode, use the authentication
command to set the access point to "Open System." Use the
WEP encryption command to enable all types of encryption. To
enable WPA to be required for all clients, use the wpa-clients
command. Use the wpa-mode command to enable the
Pre-shared Key mode. To enter a key value, use the
wpa-psk-type command to specify a hexadecimal or
alphanumeric key, and then use the wpa-preshared-key
command to define the key. Then disable 802.1x and MAC
authentication. To view the current 802.11g security settings, use
the show interface wireless g command (not shown in
example).
SMC-AP(config)#interface wireless g
Enter Wireless configuration commands, one per line.
SMC-AP(if-wireless g)#authentication open
SMC-AP(if-wireless g)#encryption 128
SMC-AP(if-wireless g)#wpa-clients required
SMC-AP(if-wireless g)#wpa-mode pre-shared-key
SMC-AP(if-wireless g)#wpa-psk-type alphanumeric
SMC-AP(if-wireless g)#wpa-preshared-key ASCII asecret 6-92
SMC-AP(if-wireless g)#end
SMC-AP(config)#no 802.1x
SMC-AP(config)#no mac-authentication
Radio Interface
5-59
6-68
6-82
6-83
6-89
6-91
6-93
6-51
6-57
Advertisement
Table of Contents
