Hardware Description - SMC Networks SMCWEBT-G User Manual

H
ARDWARE
The Wireless AP provides up to 108 Mbps connections to
Ethernet networks. This device is fully compliant with 2.4 GHz
DSSS/OFDM wireless networking as defined in IEEE 802.11b/g.
The Wireless AP is backward compatible with the existing
802.11b WLAN infrastructure. It also can be connected via an
RJ-45 connection to devices such as Nintendo GameCube,
Microsoft Xbox, Sony PlayStation II, and Ethernet ready
embedded devices. It functions as an IEEE 802.11g Access Point
or as a Repeater (see "Introduction" on page 1).
Figure 1. Rear Panel
Item Description
Power Inlet Connect the included power adapter to this inlet.
Warning: Using the wrong type of power adapter may damage
your adapter.
LAN Port Fast Ethernet port (RJ-45). Connect device (such as a PC, hub
or switch) on your network to this port.
Note: If you use the Reset button at the bottom of the device, the
Wireless AP performs a power reset. If the button is
depressed for over 8 seconds, all the LEDs will illuminate
and the factory settings will be restored.
D
ESCRIPTION
3