Hardware Installation
Set the four 5/8-inch number 12 wood screws in the holes,
leaving about 3 mm clearence from the wall.
Position the mounting bracket over the wall screws, slide the
bracket onto the screws, and then tighten down the screws.
3. Attaching the Bracket – Line up the three mounting points
on the bracket with the three mounting slots on the rear of the
access point, as directed in the figure on the next page.
Place the mounting points of the bracket into the mounting
slots of the access point and while pushing down on the
bracket, slide it into position so that the two retaining latches
slip into place over the back of the access point.
2-2